Having trouble getting my engine out...

[cnrcpla]

I am well into my newest project, and on my yz250, I can't get the engine out. I have two mounting bolts out from the bottom and front part of the frame and engine, and I have the swing arm mounting bolt out as well. I have the brackets on the top of the engine out as well as all the radiator tubes and wires. I can't find any other things holding it in, anyone know?

[cnrcpla]

Never mind... some good old brute force paid off 

[xandyx]

next time you can always try a rubber mallet or a wood piece to try to move the engine up, down or sideways.

post some pics of your rebuild!

[cnrcpla]

I started a tread in the photos and vids section. I will be posting up the before pics tonight... but be warned, everything is dirty.     And, when I couldn't get it out, I just rocked it side to side a few times and then it loosened up nicely. It must have been all the dirt and grime 

[cnrcpla]

Oops, not photos and vids section, I meant the Open forum. I am going to go take some now... its a mess 

[SachsGS]

I often use a piece of 1" by 4" wood about two feet long as a pry bar to loosen engines.